HP 1606 Converged Enhanced Ethernet Command Reference v6.4.0 (53-1001762-01, J - Page 134
permit (extended ACLs), Use the format HHHH.HHHH.HHHH.
View all HP 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
8 permit (extended ACLs) DRAFT: BROCADE CONFIDENTIAL permit (extended ACLs) Synopsis Operands Defaults Command Modes Description Usage Guidelines Example Configures a MAC address rule to permit traffic based on the source and destination MAC addresses. permit {any | host MAC _ACL| MAC_ACL} {any | host MAC _ACL| MAC _ACL} [EtherType | arp | fcoe | ipv4] [count] no permit {any | host MAC _ACL| MAC_ACL} {any | host MAC _ACL| MAC _ACL} [EtherType | arp | fcoe| ipv4] any host MAC_ACL MAC_ACL any host MAC_ACL MAC_ACL Ethertype arp fcoe ipv4 count Specifies any source MAC address. Specifies the source host MAC address for which to set permit conditions. Use the format HHHH.HHHH.HHHH. Specifies the source host MAC address for which to set permit conditions. Use the format HHHH.HHHH.HHHH. Specifies any destination MAC address. Specifies the destination host address for which to set permit conditions. Use the format HHHH.HHHH.HHHH. Specifies the destination host address for which to set permit conditions. Use the format HHHH.HHHH.HHHH. Specifies the protocol number for which to set the permit conditions. The range of valid values is 1536-65535. Specifies to permit the Address Resolution Protocol (0x0806). Specifies to permit the Fibre Channel over Ethernet Protocol (0x8906). Specifies to permit the IPv4 protocol (0x0800). Enables counting of the packets matching the filter rule. By default, no MAC ACLs are configured. Feature Access Control List Configuration mode Use this command to configure rules to match and to permit traffic based on the source and destination MAC addresses, and the protocol type. You can also enable counters for a specific rule. There are 255 ACL counters supported per port group. Use the no permit command to remove a rule from the MAC ACL. The first set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the source MAC address. The second set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the destination MAC address. To create a rule in a MAC extended ACL to permit IPv4 traffic from the source MAC address 0022.3333.4444 to the destination MAC address 0022.3333.5555 and to enable the counting of packets: switch(conf-macl-ext)#permit 0022.3333.4444 0022.3333.5555 ipv4 count 116 Converged Enhanced Ethernet Command Reference 53-1001762-01