HP 1606 Converged Enhanced Ethernet Command Reference v6.4.0 (53-1001762-01, J - Page 245
dot1x timeout tx-period, Synopsis, Operands, Defaults, Command, Modes, Description, Usage, Guidelines
View all HP 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
DRAFT: BROCADE CONFIDENTIAL dot1x timeout tx-period 13 dot1x timeout tx-period Synopsis Operands Defaults Command Modes Description Usage Guidelines Examples See Also Sets the number of seconds that the switch waits for a response to an Extensible Authentication Protocol (EAP) request or identity frame from the client before retransmitting the request. dot1x timeout tx-period seconds seconds Specifies the time in seconds between successive request ID attempts. The range of valid values is 1-65535. The default timeout is 30 seconds. Interface configuration mode Use this command to set the interval between successive attempts to request an ID (EAP ID Req). There are no usage guidelines for this command. To set 34 as the number of seconds to wait for a response to an EAP-request or identity frame from the client before retransmitting the request: switch(config)#interface tengigabitethernet 0/1 switch(config-if)#dot1x timeout tx-period 34 none Converged Enhanced Ethernet Command Reference 227 53-1001762-01