HP 1606 Fabric OS FCIP Administrators Guide v6.4.0 (53-1001766-01, November 20 - Page 78
Compression on, Fastwrite on, Tape Pipelining on, TCP Byte Streaming off
View all HP 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
3 Verifying the FCIP tunnel configuration tunnel_id Displays the specified FCIP tunnel. The following example shows an active tunnel FCIP Fastwrite and OSTP (tape pipelining) enabled. If TCP Byte Streaming were enabled, then FCIP Fastwrite and OSTP would be disabled. SP3:admin> portshow fciptunnel ge1 1 Port: ge1 Tunnel ID 1 Tunnel Description Not Configured Remote IP Addr 192.168.15.2 Local IP Addr 192.168.15.1 Remote WWN Not Configured Local WWN 10:00:00:05:1e:41:2f:2e Compression on Fastwrite on Tape Pipelining on Committed Rate 200000 Kbps (0.200000 Gbps) SACK on Min Retransmit Time 100 Keepalive Timeout 10 Max Retransmissions 8 VC QoS Mapping off DSCP Marking (Control): 0, DSCP Marking (Data): 0 VLAN Tagging Not Configured TCP Byte Streaming off Status : Inactive Connected Count: 1 If IPsec has been enabled and a policy added to the configuration, you will see the policy information under the status section of the output, as shown below. The policy information is visible only when IPsec is configured, and can be displayed by entering the portShow fciptunnel all command. switch0:admin> portshow fciptunnel ge0 all Port: ge0 Tunnel ID 0 Tunnel Description Not Configured Remote IP Addr 10.10.12.100 Local IP Addr 10.62.0.100 Remote WWN Not Configured Local WWN 10:00:00:05:1e:38:58:61 Compression on Fastwrite on Tape Pipelining on Committed Rate 1000000 Kbps (1.000000 Gbps) SACK on Min Retransmit Time 100 Keepalive Timeout 90 Max Retransmissions 9 VC QoS Mapping on DSCP Marking (Control): 45, DSCP Marking (Data): 30 VLAN Tagging Not Configured TCP Byte Streaming off Status : Inactive Connected Count: 0 64 Fabric OS FCIP Administrator's Guide 53-1001766-01