HP 3PAR StoreServ 7200 2-node HP 3PAR StoreServ 7000 Storage Service Guide (QR - Page 25

Replacing an SFP, Port details

Get HP 3PAR StoreServ 7200 2-node PDF manuals and user guides View all HP 3PAR StoreServ 7200 2-node manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

5. Replace the SFP. See "Replacing an SFP" (page 25). 6. In the HP 3PAR Management Console, verify that the SFP is successfully replaced. The replaced port State is listed as Ready, the Mode is listed as Target, and the Connected Device Type is listed as Host. Figure 23 Port details Replacing an SFP 1. After identifying the SFP that requires replacement, disconnect the cable and lift the retaining clip to carefully slide the SFP out of the slot. 2. Remove the replacement SFP module from its protective packaging. 3. Carefully slide the replacement SFP into the adapter until fully seated, close the retaining clip to secure it in place, and reconnect the cable. 4. Place the failed SFP into the packaging for return to HP. 5. Reconnect the cable to the SFP module and verify that the link status LED is solid green. SFP Repair 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
5.
Replace the SFP. See
“Replacing an SFP” (page 25)
.
6.
In the HP 3PAR Management Console, verify that the SFP is successfully replaced. The replaced
port
State
is listed as
Ready
, the
Mode
is listed as
Target
, and the
Connected Device Type
is listed as
Host
.
Figure 23 Port details
Replacing an SFP
1.
After identifying the SFP that requires replacement, disconnect the cable and lift the retaining
clip to carefully slide the SFP out of the slot.
2.
Remove the replacement SFP module from its protective packaging.
3.
Carefully slide the replacement SFP into the adapter until fully seated, close the retaining clip
to secure it in place, and reconnect the cable.
4.
Place the failed SFP into the packaging for return to HP.
5.
Reconnect the cable to the SFP module and verify that the link status LED is solid green.
SFP Repair
25