HP 48gII hp 48gII_user's manual_English_E_HDPMSG48E67_V2.pdf - Page 715

IF trap-clause THEN error-clause END IF trap-clause THEN error-clause ELSE normal-clause END The operation of these logical constructs is similar to that of the IF ... THEN ... END and of the IF ... THEN ... ELSE ... END constructs. If an error is detected during the execution of the trap-clause, then the error-clause is executed. Otherwise, the normal-clause is executed. As an example, consider the following program (@ERR1) that takes as input two matrices, A and b, and checks if there is an error in the trap clause: A b / (RPN mode, i.e., A/b). If there is an error, then the program calls function LSQ (Least SQuares, see Chapter 11) to solve the system of equations: « A b « IFERR A b / THEN LSQ END » » Try it with the arguments A = [ [ 2, 3, 5 ] , [1, 2, 1 ] ] and b = [ [ 5 ] , [ 6 ] ]. A simple division of these two arguments produces an error: /Error: Invalid Dimension. However, with the error-trapping construct of the program, @ERR1, with the same arguments produces: [0.262295..., 0.442622...]. User RPL programming in algebraic mode While all the programs presented earlier are produced and run in RPN mode, you can always type a program in User RPL when in algebraic mode by using function RPL>. This function is available through the command catalog. As an example, try creating the following program in algebraic mode, and store it into variable P2: « → X '2.5-3*X^2' » First, activate the RPL> function from the command catalog (,N). All functions activated in ALG mode have a pair of parentheses attached to their name. The RPL> function is not exception, except that the parentheses must be removed before we type a program in the screen. Use the arrow keys (š™) and the delete key (ƒ) to eliminate the parentheses from the RPL>() Page 21-66