HP 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel Switch CIM Agent Refer - Page 25
Not Supported: NS/Remote Ports Method applies to local ports, Use of Timeout Parameter Not Supported.
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Property contains the value 5=No Change. All port state changes are atomic; there is no pending requested state. (NS/Remote) Property contains the enumerated value 12=Not Applicable. EnableDefault (Local) Property contains the configured port state. • 02-Enabled: Port is enabled • 03-Disabled: Port is disabled (NS/Remote) • Property contains the enumerated value 5=Not Applicable. RequestStateChange (Local only) Method changes the configured port state to the RequestedState value. If the RequestedState parameter is 11-Reset, the port is reset, but the configured state does not change. Parameters: • RequestedState: [required] A port specific array of valid values may be found in the FCPortCapabilities.RequestedStatesSupported property. Parameter must be one of the following enumerated values. • 2-Enabled: Port is online. • 3-Disabled: Port is offline • 7-Test: Port is in diagnostics mode. • 11-Reset: Port is reset. • Job: Ignored, command is synchronous. • TimeoutPeriod: must be zero second interval, or NULL, command is synchronous. Method Returns: • 0-Success • 1-Not Supported: (NS/Remote Ports) Method applies to local ports only. • 6-In Use: Switch is being configured by another user. • 4097-Invalid State Transition: RequestedState parameter value is out of range. • 4098-Use of Timeout Parameter Not Supported. Request Status Codes: • CIM_ERR_ACCESS_DENIED: User does not have authorization for this command. • CIM_ERR_INVALID_PARAMETER: One or more required parameters are missing. • CIM_ERR_NOT_FOUND: The FCPort instance was not found. Extended properties and methods HealthState (Local Only) Property reports the diagnostic status of the port as a result of the switch POST. Supported values are: • 0-Unknown Port is not installed • 5-OK No errors • 25-Critical Failure Port failed POST IOStreamGuardState (Local Only) HP StorageWorks 8/20q and SN6000 Fibre Channel Switch CIM Agent Reference Guide 25