HP Cisco MDS 9020 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 253
vrf context
View all HP Cisco MDS 9020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
Chapter 2 Ethernet Commands vrf context Send comments to [email protected] vrf context To create a virtual routing and forwarding instance (VRF) and enter VRF configuration mode, use the vrf context command. To remove a VRF entry, use the no form of this command. vrf context {name | management} no vrf context {name | management} Syntax Description name management Name of the VRF. Specifies a configurable VRF name. Command Default None Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines When you enter the VRF configuration mode, the following commands are available: • exit-Exits from the current command mode. • ip-Enables configuration of IP features. Additional commands available in IP configuration mode: - domain-list-Adds additional domain names. - domain-lookup-Enables or disables DNS lookup. - domain-name-Specifies the default domain name. - host-Adds an entry to the IP hostname table - name-server-Specifies the IP address of a DNS name server - route-Adds route information by specifying IP addresses of the next hop servers. • no-Negates a command or set its defaults. • shutdown-Shuts down the current VRF context. Examples This example shows how to enter VRF context mode: switch(config)# vrf context management switch(config-vrf)# OL-16599-01 Cisco Nexus 5000 Series Command Reference 2-105