HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 951

Chapter 21 S Commands sme Send documentation comments to [email protected] sme To enable or disable the Cisco SME services, use the sme command. sme {auto-save | cluster name | enable | transport pre-shared key key identifier cluster cluster } Syntax Description auto-save cluster name enable transport pre-shared key key identifier cluster name Enables or disables the auto-configuration save after the changes are made. Identifies the cluster name. The maximum length is 32 characters. Enables or disables Cisco SME on the crypto mode. Configures the transport preshared key (PSK). Configures transport PSK. Specifies the PSK. The maximum length is 64 characters. Identifies the cluster. The maximum length is 64 characters. Defaults Disabled. Command Modes Configuration mode. Command History Release 3.2(2) Modification This command was introduced. Usage Guidelines Cisco SME services must be enabled to take advantage of the encryption and security features. To use this command, you must enable Cisco SME clustering using the cluster enable command. Examples The following example shows how to enable the Cisco SME service: switch# config t switch(config)# sme enable switch(config)# The following example shows how to disable the Cisco SME service: switch# config t switch(config)# no sme enable switch(config)# The following example shows how to enable automatic configuration save after the changes: switch# config t switch(config)# sme auto-save switch(config) OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 21-33