HP Cisco MDS 9124 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 175

Chapter 2 Ethernet Commands lacp system-priority Send comments to [email protected] lacp system-priority To set the system priority of the switch for the Link Aggregation Control Protocol (LACP), use the lacp system-priority command. To return the system priority to the default value, use the no form of this command. lacp system-priority priority no lacp system-priority Syntax Description priority Priority for the physical interfaces. The range of valid numbers is from 1 to 65535. Command Default System priority value is 32768. Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines Each device that runs LACP has an LACP system priority value. You can configure a value between 1 and 65535. LACP uses the system priority with the MAC address to form the system ID and also during negotiation with other systems. When setting the priority, note that a higher number means a lower priority. Examples This example shows how to set the LACP system priority for the device to 2500: switch(config)# lacp system-priority 2500 Related Commands Command show lacp Description Displays LACP information. OL-16599-01 Cisco Nexus 5000 Series Command Reference 2-27