HP Cisco MDS 9124 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 244

switchport private-vlan host-association Chapter 2 Ethernet Commands Send comments to [email protected] switchport private-vlan host-association To define a private VLAN association for an isolated or community port, use the switchport private-vlan host-association command. To remove the private VLAN association from the port, use the no form of this command. switchport private-vlan host-association {primary-vlan-id} {secondary-vlan-id} no switchport private-vlan host-association Syntax Description primary-vlan-id secondary-vlan-id Number of the primary VLAN of the private VLAN relationship. Number of the secondary VLAN of the private VLAN relationship. Command Default None Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines There is no run-time effect on the port unless it is in private VLAN-host mode. If the port is in private VLAN-host mode but neither of the VLANs exist, the command is allowed but the port is made inactive. The port also may be inactive when the association between the private VLANs is suspended. The secondary VLAN may be an isolated or community VLAN. See the private-vlan command for more information on primary VLANs, secondary VLANS, and isolated or community ports. Note A PVLAN isolated port on a Cisco Nexus 5000 Series switch running the current release of Cisco NX-OS does not support IEEE 802.1q encapsulation and cannot be used as a trunk port. Examples This example shows how to configure a Layer 2 host private VLAN port with a primary VLAN (VLAN 18) and a secondary VLAN (VLAN 20): switch(config-if)# switchport private-vlan host-association 18 20 This example shows how to remove the private VLAN association from the port: switch(config-if)# no switchport private-vlan host-association 2-96 Cisco Nexus 5000 Series Command Reference OL-16599-01