HP Cisco MDS 9134 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 422

debug logfile Chapter 6 Debug Commands Send documentation comments to [email protected] debug logfile To direct the output of the debug commands to a specified file, use the debug logfile command in EXEC mode. To disable a debug command, use the no form of the command or use the no debug all command to turn off all debugging. debug logfile filename [size bytes] Syntax Description filename size bytes Assigns the name of the log file. Maximum length is 80 characters. Specifies the logfile size in bytes. The range is 4096 to 4194304. Defaults Disabled. Command Modes EXEC mode. Command History Release 1.0(2) Modification This command was introduced. Usage Guidelines Use this command to log debug messages to a special log file. This file is more secure and easier to process than sending the debug output to the console. When you use the debug logfile command to create a log file, the file is automatically created in the log: directory on the supervisor module unless you specify a different path. For example, using the debug logfile command to created a log file named captureDebug, you must enter the dir log://sup-local/? command to find the log file you created. Following example shows you how to find the log file created. switch# debug logfile captureDebug switch# dir log://sup-local/? log: Enter URL "log:[//]/" log://sup-local/dmesg log://sup-local/messages log://sup-local/captureDebug switch# dir log://sup-local/ Examples The following example redirects the output of the debug commands to the file named sample. switch# debug logfile sample The following example assigns the log file size for the file named sample. switch# debug logfile sample size 410000 6-76 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x