HP Cisco MDS 9134 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 568

flex-attach virtual-pwwn auto Chapter 8 F Commands Send documentation comments to [email protected] flex-attach virtual-pwwn auto To enable the FlexAttach virtual port WWN (pWWN) on a specific interface, use the flex-attach virtual-pwwn auto command. To disable the virtual pWWN, use the no form of the command. flex-attach virtual-pwwn auto [interface auto interface-list] no flex-attach virtual-pwwn auto [interface auto interface-list] Syntax Description interface auto interface-list Specifies the interface list on which FlexAttach virtual pWWN should be enabled. Note All interfaces in the interface-list value must be in the shut mode. If the interface-list value is not provided, then all ports must be in the shut mode. Defaults None. Command Modes Configuration mode Command History Release 3.3(1a) Modification This command was introduced. Usage Guidelines The NPV switch assigns the virtual pWWNs to the interface on which FlexAttach is enabled. Examples The following example shows how to enable FlexAttach virtual pWWN on a interface. switch# config Enter configuration commands, one per line. End with CNTL/Z. switch#(config)# flex-attach virtual-pwwn auto interface fc 1/1 Related Commands Command flex-attach virtual-pwwn interface Description Sets the user-specific FlexAttach virtual pWWN. 8-78 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x