HP Cisco MDS 9216A Cisco MDS 9500 Series Hardware Installation Guide (OL-17467 - Page 178
Migration Procedure for the MDS 9509 Director and MDS 9506 Director
View all HP Cisco MDS 9216A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
Appendix A Migrating to Generation 3 8-Gbps Fibre Channel Switching Modules Migration Procedure for the MDS 9509 Director and MDS 9506 Director Send documentation comments to [email protected]. Step 9 switch# show hardware fabric-mode Fabric mode supports Gen3 and above linecards. switch# Refer to the Cisco MDS 9000 Family CLI Configuration Guide or Cisco MDS 9000 Family Fabric Manager Configuration Guide for information on how to configure the MDS 9000 48-port or 24-port 8-Gbps Fibre Channel modules. Migration Procedure for the MDS 9509 Director and MDS 9506 Director Note Do not upgrade to NX-OS 4.1(1b) if a Supervisor-1 module is installed. To use any Generation 3 8-Gbps module in an MDS 9509 Director or MDS 9506 Director, follow these steps: Step 1 Step 2 Step 3 Step 4 Log in to the switch. Verify that the switch is running Cisco NX-OS 4.1(1b) by entering the show version command. If the switch has NX-OS 4.x or higher installed, then Supervisor-2 module is already installed on the switch. Skip to step 7 to install any Generation 3 8-Gbps module. Enter the show module command to determine which supervisor module is in active mode and which is in standby module. Supervisor modules are installed in slot 5 and slot 6 on the MDS 9509 Director and MDS 9506 Director. The following example shows the output of the show module command: switch# show module Mod Ports Module-Type Model Status 4 22 4x1GE IPS, 18x1/2/4Gbps FC Modul DS-X9304-18K9 ok 5 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 active * 6 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 ha-standby Mod Sw Hw World-Wide-Name(s) (WWN) 4 4.1(0.182) 0.304 20:c1:00:05:30:00:a7:9e to 20:d2:00:05:30:00:a7:9e 5 4.1(0.182) 4.0 -- 6 4.1(0.182) 0.0 -- Mod MAC-Address(es) Serial-Num 4 00-19-56-be-65-d0 to 00-19-56-be-65-d8 JAB1107027K 5 00-0c-30-0d-2b-b8 to 00-0c-30-0d-2b-bc JAB074004VE 6 00-05-30-00-52-f2 to 00-05-30-00-52-f6 NA If the switch has Supervisor-1 modules installed, remove the modules according to the instructions in the "Removing Supervisor Modules" section on page 2-39. If the switch has Supervisor-2 modules installed, then skip to Step 6. A-12 Cisco MDS 9500 Series Hardware Installation Guide OL-17467-02