HP Cisco MDS 9216A Cisco MDS 9500 Series Hardware Installation Guide (OL-17467 - Page 211
Installing the Cisco MDS 9500 Shelf Bracket Kit into a Cabinet or Rack
View all HP Cisco MDS 9216A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
Appendix C Cabinet and Rack Installation Cisco MDS 9500 Shelf Bracket Send documentation comments to [email protected]. Installing the Cisco MDS 9500 Shelf Bracket Kit into a Cabinet or Rack Figure C-3 shows the installation of the Cisco MDS 9500 Shelf Bracket Kit into a four-post rack. Figure C-3 Installing the Shelf Bracket Kit into a Rack 1120012 To install the shelf brackets in a cabinet or rack, follow these steps: Step 1 Position a shelf bracket inside the rack-mounting rails as shown in Figure C-3. Align the screw holes at the front of the shelf bracket with the holes in the front rack-mounting rail, and then attach the shelf bracket to the front rack-mounting rail using a minimum of four 1/4-20 screws. Note The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the rack-mounting rail (the hole immediately above the 1/2-inch spacing). Step 2 Step 3 Step 4 Align the screw holes at the back of the shelf bracket with the holes in the back rack-mounting rail, and then attach the shelf bracket to the back rack-mounting rail using a minimum of four 1/4-20 screws. Repeat Step 1 and Step 2 with the other shelf bracket. Verify that the shelf brackets are at the same height (using the level or tape measure as desired). OL-17467-02 Cisco MDS 9500 Series Hardware Installation Guide C-15