HP Cisco MDS 9216i Cisco MDS 9500 Series Hardware Installation Guide (OL-17467 - Page 172
show module, Step 5
View all HP Cisco MDS 9216i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
Migration Procedures for the MDS 9513 Director Appendix A Migrating to Generation 3 8-Gbps Fibre Channel Switching Modules Send documentation comments to [email protected]. Step 5 Step 6 Step 7 Step 8 switch# show module Mod Ports Module-Type Model Status 7 0 8 0 Supervisor/Fabric-2 Supervisor/Fabric-2 DS-X9530-SF2-K9 DS-X9530-SF2-K9 ha-standby active * switch# out-of-service xbar 1 Enter the show module xbar command to verify that the standby supervisor module is powered down. Attach a ESD wrist strap according to the instructions in the section "Preventing Electrostatic Discharge Damage" section on page 2-19. Confirm that the LED light is red, which indicates that the module is powered off, and then loosen the two captive screws on the module being removed. Remove the module from the chassis as follows: a. Place your thumbs on the top and bottom ejector levers and simultaneously rotate the levers outward to unseat the module from the midplane connector. (See Figure A-1) b. Hold the front edge of the module and slide the module partially out of the slot. Do not touch the module circuitry. Cisco MDS 9500 Series Hardware Installation Guide A-6 OL-17467-02