HP Cisco MDS 9216i Cisco MDS 9500 Series Hardware Installation Guide (OL-17467 - Page 42
Table 1-4, LEDs for the Cisco MDS 9500 Series Supervisor-2 Modules, Activity LED
View all HP Cisco MDS 9216i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Supervisor Modules Chapter 1 Product Overview Send documentation comments to [email protected]. Table 1-4 LEDs for the Cisco MDS 9500 Series Supervisor-2 Modules LED Status Description Status Green All diagnostics pass. The module is operational (normal initialization sequence). Orange One of the following occurs: • The module is booting or running diagnostics (normal initialization sequence). • An over-temperature condition occurred (a minor threshold was exceeded during environmental monitoring). Red One of the following occurred: • The diagnostic test failed. The module is not operational because a fault occurred during the initialization sequence. • An over-temperature condition occurred (a major threshold was exceeded during environmental monitoring). System Green All chassis environmental monitors are reporting OK. Orange One of the following occurred: • The power supply failed or the power supply fan failed. • Incompatible power supplies are installed. • The redundant clock failed. Red The temperature of the supervisor module exceeded the major threshold. Active Green The Supervisor-2 module is operational and active. Orange The Supervisor-2 module is in standby mode. Power Green Sufficient power is available for all modules. Management Orange Sufficient power is not available for all modules. MGMT 10/100/1000 Ethernet Link LED Green Off Link is up. No link. MGMT 10/100 Green Ethernet Off Activity LED Traffic is flowing through port. No link or no traffic. CompactFlash Green The external CompactFlash card is being accessed. Off No activity. 1-20 Cisco MDS 9500 Series Hardware Installation Guide OL-17467-02