HP Cisco MDS 9216i Cisco MDS 9500 Series Hardware Installation Guide (OL-17467 - Page 67

Chapter 1 Product Overview Services Modules Send documentation comments to [email protected]. Figure 1-28 shows an MPS-14/2 module. Figure 1-28 Cisco MDS 9000 Family MPS-14/2 Module 2 4 STATUS 1 2 3 4 5 6 7 8 9 10 11 12 13 14 LINK- 1 2 LINK- GIGABIT E THERNET LINK- -SPEED LINK- -SPEED LINK- -SPEED 1 3 5 6 116889 1 Status LED 4 Gigabit Ethernet ports 2 1-Gbps/2-Gbps Fibre Channel ports 5 Link LEDs 3 Link LEDs (under ports, on left) and Speed LEDs 6 Asset tag (under the ports, on the right) LEDs on the MPS-14/2 Module Table 1-16 describes the LEDs for the MPS-14/2 modules. Table 1-16 LEDs for the Cisco MDS 9000 Family MPS-14/2 Modules LED Status Status Green Orange Red Speed On Off Description All diagnostics pass. The module is operational (normal initialization sequence). One of the following occurs or occurred: • The module is booting or running diagnostics (normal initialization sequence). • The inlet air temperature of the system exceeded the maximum system operating temperature limit (a minor environmental warning). To ensure maximum product life, you should immediately correct the environmental temperature and restore the system to normal operation. One of the following occurred: • The diagnostic test failed. The module is not operational because a fault occurred during the initialization sequence. • The inlet air temperature of the system exceeded the safe operating temperature limits of the card (a major environmental warning). The card shut down to prevent permanent damage. 2-Gbps mode. 1-Gbps mode. OL-17467-02 Cisco MDS 9500 Series Hardware Installation Guide 1-45