HP Cisco MDS 9216i Cisco MDS 9000 Family Fabric Manager Configuration Guide, R - Page 578

Default Settings Chapter 29 Configuring Inter-VSAN Routing Send documentation comments to [email protected] • If the failure is due to exceeding the maximum configuration limits in a fabric where the switches are running more than one Cisco SAN-OS release, then either upgrade the switches running the earlier release or reduce the number of IVR zones and IIVR zone members on the switches running the more recent release to the earlier release limit (see the"IVR Limits Summary" section on page 29-4). • If the failure is due to exceeding maximum limits in a fabric where all switches are running the same Cisco SAN-OS release, identify the switch that has the correct configuration and perform a CFS commit to distribute the IVR configuration (see the "Configuring Default AFIDs" section on page 29-12 and the"IVR Limits Summary" section on page 29-4). • For other failures, resolve the error causing the merge failure on the switch that has the correct configuration and perform a CFS commit to distribute the IVR configuration (see the "Configuring Individual AFIDs" section on page 29-13). After a successful CFS commit, the merge will be successful. Default Settings Table 29-6 lists the default settings for IVR parameters. Table 29-6 Default IVR Parameters Parameters IVR feature IVR VSANs IVR NAT QoS for IVR zones Configuration distribution Default Disabled. Not added to virtual domains. Disabled. Low. Disabled. 29-34 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x