HP Cisco MDS 9216i Cisco MDS 9000 Family Fabric Manager Configuration Guide, R - Page 918

Port Security Manual Configuration Chapter 46 Configuring Port Security Send documentation comments to [email protected] • By saving the running configuration, you save the configuration database and activated entries in the active database. Learned entries in the active database are not saved. Adding Authorized Port Pairs After identifying the WWN pairs that need to be bound, add those pairs to the port security database. Tip Remote switch binding can be specified at the local switch. To specify the remote interfaces, you can use either the fWWN or sWWN-interface combination. To add authorized port pairs for port security using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Expand a VSAN and select Port Security in the Logical Domains pane. Click the Config Database tab. Click Create Row to add an authorized port pair. You see the Create Port Security dialog box shown in Figure 46-10. Figure 46-10 Create Port Security Dialog Box Step 4 Step 5 Step 6 Step 7 Double-click the device from the available list for which you want to create the port security setting. Double-click the port from the available list to which you want to bind the device. Click Create to create the port security setting. Click the Apply Changes icon to save these changes. Deleting Port Security Setting To delete a port security setting from the configured database on a switch, follow these steps: 46-18 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x