HP Cisco MDS 9222i Cisco MDS 9500 Series Hardware Installation Guide (OL-17467 - Page 137
Installing an AC Power Supply in the Cisco MDS 9509 Director
View all HP Cisco MDS 9222i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Chapter 2 Installing the Cisco MDS 9500 Series Removing and Installing a Power Supply or PEM Send documentation comments to [email protected]. Figure 2-30 Handling a Power Supply for the Cisco MDS 9509 Director 91687 Installing an AC Power Supply in the Cisco MDS 9509 Director The procedure for installing an AC power supply in the Cisco MDS 9509 Director is the same for the 4000-W, 3000-W, and 2500-W power supplies, except that the power cable for the 4000-W power supply is hardwired to the power supply. Caution Use both hands to install and remove power supplies. Each Cisco MDS 9509 AC power supply weighs up to 28 lb (12.6 kg). The 4000-W and 2500-W power supplies weigh up to 28 lb (12.6 kg). The 3000-W power supply weighs up to 24 lb (11 kg). To install an AC power supply in the Cisco MDS 9509 Director, follow these steps: Step 1 Step 2 Ensure that the system (earth) ground connection has been made. See the "System Grounding" section on page 2-17. If a filler panel is installed, remove the filler panel from the power supply bay by loosening the captive screw. OL-17467-02 Cisco MDS 9500 Series Hardware Installation Guide 2-57