HP Cisco MDS 9222i Cisco MDS 9500 Series Hardware Installation Guide (OL-17467 - Page 147
Removing an AC or DC Power Supply from the Cisco MDS 9506 Director, Installing an AC or DC Power
View all HP Cisco MDS 9222i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
Chapter 2 Installing the Cisco MDS 9500 Series Removing and Installing a Power Supply or PEM Send documentation comments to [email protected]. • OUTPUT FAIL LED is off. Removing an AC or DC Power Supply from the Cisco MDS 9506 Director The procedure for removing a Cisco MDS 9506 power supply is the same for AC and DC power supplies. To remove an AC or DC power supply from the Cisco MDS 9506 Director, follow these steps: Step 1 Step 2 Step 3 Remove power from the PEM that corresponds to the power supply as follows: • If the PEM is AC, press the power switch to off (0). • If the PEM is DC, follow the instructions in the "Removing a DC PEM" section on page 2-64. Loosen the captive screws on the power supply. Grasp both power supply handles as shown in Figure 2-36 and slide the power supply completely out of the chassis. Figure 2-36 Handling a Power Supply for the Cisco MDS 9506 Director OUTPUT FAIL FAN OK INPUT OK 91714 OUTPUT FAIL FAN OK INPUT OK Step 4 If the power supply bay is to remain empty, install a filler panel over the opening and tighten the captive screws to 8 in-lb. Installing an AC or DC Power Supply in the Cisco MDS 9506 Director The procedure for installing a Cisco MDS 9506 power supply is the same for AC and DC power supplies. To install an AC or DC power supply in the Cisco MDS 9506 Director, follow these steps: OL-17467-02 Cisco MDS 9500 Series Hardware Installation Guide 2-67