HP Cisco MDS 9222i Cisco MDS 9500 Series Hardware Installation Guide (OL-17467 - Page 206
Installing the Shelf Bracket Kit into a Four-Post EIA Rack
View all HP Cisco MDS 9222i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 206 highlights
Cisco MDS 9000 Family Telco and EIA Shelf Bracket Appendix C Cabinet and Rack Installation Send documentation comments to [email protected]. Installing the Shelf Bracket Kit into a Four-Post EIA Rack Figure C-2 shows the installation of the shelf bracket kit into a four-post EIA rack. Figure C-2 Installing the Shelf Bracket Kit into an EIA Rack 1 2 3 4 5 105087 1 Rack-mounting rail (4x) 2 Shelf bracket (2x) 3 Slider rail (2) 4 Crossbar 5 10-32 screws (2x) To install the shelf brackets in an EIA rack, follow these steps: Step 1 Position a shelf bracket inside the rack-mounting rails as shown in Figure C-2. Align the screw holes at the front of the shelf bracket with the holes in the front rack-mounting rail. Then attach the shelf bracket to the front rack-mounting rail using a minimum of four 12-24 or 10-24 screws. Note The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the rack-mounting rail (the hole immediately above the 1/2-in. spacing). Step 2 Repeat with the other shelf bracket. Step 3 Verify that the shelf brackets are at the same height (using the level or tape measure as desired). C-10 Cisco MDS 9500 Series Hardware Installation Guide OL-17467-02