HP Color LaserJet 5550 HP Color LaserJet 5550 series - User Guide - Page 193
Unable To Mopy Job - unable to store job at printer
View all HP Color LaserJet 5550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
Control panel messages (continued) Control panel message Description Recommended action TRAY XX SIZE= Recommend move switch to STANDARD alternates with TRAY XX SIZE= Then close tray A detectable media size was selected from the menu and the tray is open. Although not required, the size selected can be automatically sensed if the tray switch is moved to STANDARD. 1. Adjust the side and rear media guides against the paper. 2. If the media used is letter, A4, executive, JIS B5, A5, or legal, the tray switch should be set to STANDARD. Set the tray switch to CUSTOM for all other media sizes. The tray switch must be set before the size can be selected from the control panel. TYPE MISMATCH IN TRAY X For help press alternates with Ready The media type loaded in the tray does not match the media type configured for the tray. 1. Adjust the side and rear guides against the paper. 2. If size is a detectable size, set the tray switch to STANDARD, otherwise set the tray switch to CUSTOM. 3. If necessary, press after the tray is closed to change the paper size or type. Unable To Mopy Job alternates with Processing... A Mopy job cannot be mopied because Install additional memory in the printer or of a memory, disk, or configuration install a disk drive in the printer. problem. Only one copy will be produced. Unable To Store Job alternates with Processing... A job cannot be stored because of a memory, disk, or configuration problem. Install additional memory in the printer, or install a disk drive into the printer. If a disk drive is installed, delete previously stored print jobs. USE TRAY X Size detected by tray alternates with Tray X To change size or type press The printer is reporting the current configuration of tray X. The tray switch is in the STANDARD position. 1. If the configuration of the size and type is correct, press the message. to clear 2. To change media size or type, press . Use and to highlight the size or type, and then press to select. 3. If action is required to change the size, a message with instructions will appear after the selection is attempted. USE TRAY X To change press / To use press The printer is offering a selection of alternate media to use for the print job. 1. View tray configurations (type and size) using and . 2. Press to select a tray to use. Wait for printer to reinitialize RAM disk settings have been changed before the printer automatically restarts, or external device modes have changed or the printer is coming out of the diagnostics mode and will automatically restart. No action necessary. ENWW Control panel messages 179