HP Color LaserJet 9500 HP Color LaserJet 9500n/9500hdn - User Reference Guide - Page 323
Tr_8022, Tr_snap, Single Routes
View all HP Color LaserJet 9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 323 highlights
Item IPX/SPX LINK SPEED Values ENABLE FRAME TYPE SOURCE ROUTING AUTO 10T HALF 10T FULL 100T HALF 100T FULL Explanation Use the ENABLE submenu to select whether the IPX/ SPX protocol is enabled (ON) or disabled (OFF). Use FRAME TYPE to select the frame type setting for your network. The frame submenu includes these values: AUTO (default): Automatically sets and limits the frame type to the first one detected. EN_8023, EN_II, EN_8022, and EN_SNAP: Frame type selections for Ethernet networks. TR_8022, TR_SNAP: Frame type selections for Token Ring networks. The SOURCE ROUTING submenu is for a Token Ring network only. Use it to specify the NetWare Token Ring Source Routing parameter from the following options: AUTO (default): The type of source routing that is required on the network is automatically sensed. OFF: All packets are sent without source routing, and only packets from the same ring are received. ALL ROUTES and SINGLE ROUTES: All packets are sent with source routing (broadcasts and when the route is unknown). (10/100Base-TX print servers only) Use this item to select the network link speed and communication mode for the 10/100Base-TX print server. For proper communications, the Jetdirect settings must match the network. AUTO (default): The print server will automatically configure itself to match the network's link speed and communication mode. If it fails, 100TX HALF is set. 10T HALF: 10Mbps, half-duplex operation. 10T FULL: 10 Mbps, full-duplex operation. 100T HALF: 100 Mbps, half-duplex operation 100T FULL: 100 Mbps, full-duplex operation B Control panel menus 321