HP DL760 HP ProLiant DL760 Generation 2 Server Upgrade Poster - Page 3

Continued on next Rotate the power supply handle downward 2 and slide

Get HP DL760 - ProLiant - G2 PDF manuals and user guides
UPC - 613326397428
View all HP DL760 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

2. Remove the processor and memory module from the chassis by pressing in the module stop latches (1) and pulling the module out of the chassis (2). The processor and memory module will not be reused. To remove the server midplane, disengage the power supplies and the media module. To remove the power supplies: 1. Squeeze upward on the release in the middle of the power supply 1 handle (1). 2. Rotate the power supply handle downward (2) and slide forward (3). Ensure power supply 1 is disengaged from the midplane. 3. Repeat steps 1 and 2 for power supply 2. To remove the I/O module: 1. Release the I/O module by pressing in the sides of the module release levers (1) and rotating the top of the levers downward (2). Pull the module out of the chassis until it reaches the module stop latches (3). To release the media module: 1. Press in the sides of the cam levers on the media module (1) and rotate the tops of the levers downward (2). 2. Pull the media module out of the chassis until the module makes contact with the module stop latches (3). 2. Remove the I/O module from the chassis by pressing in the module stop latches (1) and pulling the module out of the chassis (2). The I/O module will not be reused, but any I/O expansion boards must be transferred to the new I/O module. Continued on next page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
2.
Remove the processor and memory module from the
chassis by pressing in the module stop latches (1) and
pulling the module out of the chassis (2). The processor
and memory module will not be reused.
To remove the I/O module:
1.
Release the I/O module by pressing in the sides of the
module release levers (1) and rotating the top of the levers
downward (2). Pull the module out of the chassis until it
reaches the module stop latches (3).
2.
Remove the I/O module from the chassis by pressing in
the module stop latches (1) and pulling the module out of
the chassis (2). The I/O module will not be reused,
but any I/O expansion boards must be transferred
to the new I/O module.
To remove the server midplane, disengage the power supplies
and the media module. To remove the power supplies:
1.
Squeeze upward on the release in the middle of the power
supply 1 handle (1).
2.
Rotate the power supply handle downward (2) and slide
forward (3). Ensure power supply 1 is disengaged from
the midplane.
3.
Repeat steps 1 and 2 for power supply 2.
To release the media module:
1.
Press in the sides of the cam levers on the media module
(1) and rotate the tops of the levers downward (2).
2.
Pull the media module out of the chassis until the module
makes contact with the module stop latches (3).
Continued on next page