HP Dc5700 HP ProtectTools Security Manager Guide - Page 20
Setup Procedures
UPC - 882780819535
View all HP Dc5700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Setup Procedures CAUTION To reduce security risk, it is highly recommended that the IT administrator immediately initialize the TPM embedded security chip. If the TPM embedded security chip is not initialized, an unauthorized user or a computer worm could gain access to the computer or a virus could initialize the TPM embedded security chip and restrict access to the PC. The TPM embedded security chip can be enabled in the BIOS Computer Setup utility, BIOS Configuration for ProtectTools, or HP Client Manager. To enable the TPM embedded security chip: 1. Open Computer Setup by turning on or restarting the computer, and then pressing F10 while the F10 = ROM Based Setup message is displayed in the lower-left corner of the screen. 2. Use the arrow keys to select Security > Setup Password. Set a password. 3. Select Embedded Security Device. 4. Use the arrow keys to select Embedded Security Device-Disable. Use the arrow keys to change it to Embedded Security Device-Enable. 5. Select Enable > Save changes and exit. NOTE Refer to the ProtectTools Help screens for specific instructions for ProtectTools Embedded Security. 14 Chapter 3 HP Embedded Security for ProtectTools ENWW