HP Designjet 2000/3000cp Service Manual - Page 14

D16. Erase EEROM Purpose Ć To clear the EEROM. If D1600 OK" Ć EEROM erased correctly. If D1601 Fail" Ć Replace Electronics Module. D17. Reset Counters Purpose Ć To reset the internal counters. If D1700 OK" Ć Counters reset correctly. If D1701 Fail" Ć Replace Electronics Module. D19. Hard Disk Drive Revision Purpose Ć To show the revision of the internal Hard Disk Drive. Calibrations Entering the Service Calibrations Menu System 1 Hold the UP and ENTER keys down and switch printer ON from the power switch on the back of the printer. Wait until Status/Initializing" is displayed before releasing keys. 2 Once Status/Ready" is displayed, scroll to Utilities / Service Tests / Calibrations and press Enter button. Use Arrow buttons to scroll through selections and press Enter button to begin a specific calibration. Calibrations To Be Done When Required C01 C02 C03 C04 C05 C06 C07 C08 Electronics Module is replaced Carriage is disassembled or replaced Yes Yes Yes No Yes Yes Yes Yes Yes Yes Yes No Yes Yes Yes Yes Refill Assembly is disassembled or replaced Line Sensor is disassembled or replaced No Yes No No Yes No Yes No No No Yes No Yes Yes Yes Yes Service station is disassembled or replaced No No No No No No No No XĆaxis Assembly is disassembled or replaced No No No No No No No Yes Drive Roller is disassembled or replaced No No No No No No No Yes Banding Problem Edge Detect Problem No No Yes No Yes Yes No Yes No No Yes No No No No No Misalignment between Colors Color Accuracy Problem No No Yes No Yes Yes No Yes No No Yes No No No Yes No Nozzles Out or Misdirected No No No No No Yes No No 12 Quick Reference Service Manual HP DesignJet 2500CP and 2000CP Printers