HP Designjet 2000/3000cp Service Manual - Page 17

C09. Maintenance Purpose Ć To read and, if necessary, adjust the preventive maintenance counter, which counts the number of swaths. This Calibration must be used to reset the Maintenance counter to ZERO after the Preventive Maintenance Kit has been installed in order to disable the Maintenance Advised" message on the frontĆpanel. Note down the Swaths Counter (####) before replacing the Electronics Module. Adjust the Swaths Counter (####) after replacing the Electronics Module. Use the following keys to adjust the swaths counter. D Up Arrow Ć Increase the Counter Digit. D Down Arrow Ć Decrease the Counter Digit. D Enter Ć Select the Next digit. C10. Font Type Set (Only available in HP DesignJet 2500CP printer) Purpose Ć To check and, if necessary, select a Font type (only possible when the printer detects that a new Hard Disk has been installed). YOU MUST PERFORM THIS CALIBRATION WHEN YOU INSTALL A NEW ELECTRONICS MODULE IN ORDER TO SET THE CORRECT FONT TYPE. If you have not installed a new Electronics Module, current font type will be displayed. If you have installed a new Electronics Module, Character Set New" will be displayed. Press Up Arrow key to set new type font. The message Choose Character Set" will be displayed on the frontĆpanel. Use Up and Down Arrow keys to select font type required and then press Enter. The first time a PostScript print is sent to the printer, the other font types will be deleted and cannot be recovered. IF YOU DO NOT SELECT ANY FONT SET, THE ROMAN FONT WILL BE SELECTED BY DEFAULT WHEN A POSTSCRIPT FILE IS SENT. HP DesignJet 2500CP and 2000CP Printers Quick Reference Service Manual 15