HP Designjet 700 Service Manual - Page 131
xxxx, Possible defective PostScript SIMM.
View all HP Designjet 700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Error Code 02002x Problem Description Firmware error related in most cases to the PostScript process. (x = values 0Ć9 hex) Corrective Actions D Possible defective PostScript SIMM. Also check that the PostScript SIMM is installed in the second slot from the top on the Main PCA. 030010 Excess friction in pen capping assembly D Check the sled movement in the service station, simulating the entering operation of parking the carriage. D Replace the service station ' page 6Ć42. 04xxxx MIO interface error. D If an MIO is installed, check the MIO setup. If necessary, replace the MIO. D Check/replace the main PCA ' page 6Ć9. 040601 The MIO card does not support the MIO 6 protocol. Cards with version 5 or below can not be used with this plotter. Version 5.1 cards behave as expected but do not support PML instructions. D Install the latest version of the MIO card. 05xxxx MIO system error. D Check/replace the main PCA ' page 6Ć9. 06030A Mark position not found. D Perform the mark position test ' page 8Ć44. 06030B Bad ambient temperature read. D Replace the cartridges. D Replace the carriage PCA. 060308 060309 Problem with Pen Voltage Control. D Replace the cartridges. D Replace the carriage PCA. C4705-90000 Troubleshooting 8-13