HP Designjet T1500 HP Designjet T920 and T1500 ePrinter series - User's Guide - Page 194
Front-panel error messages, Table 21-2 - error codes
View all HP Designjet T1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
Table 21-2 Numerical error codes Error code Recommendation 05.5:10 Update the printer's BIOS. 08:04 Restart the printer. If the problem persists, update the printer's firmware. See Update the firmware on page 137. 08:08 Retry the operation that you were attempting. If it fails again, restart the printer. If the problem persists, update the printer's firmware. See Update the firmware on page 137. 39.1:01 Roll 1 has been unexpectedly unloaded. Reload the roll. 39.2:01 Roll 2 has been unexpectedly unloaded. Reload the roll. 61:01 The file format is wrong and the printer cannot process the job. ● Turn off the printer using the Power button at the front. ● Turn off the power switch at the rear. ● Disconnect the power cord. ● Reconnect the power cord and turn on the printer. ● Send the same job to the printer again. ● Ensure that the printer's firmware is up to date. See Update the firmware on page 137. 61:04.1, 61:04.2 Update your printer's firmware. See Update the firmware on page 137. 61:08 Resend the job. 61:08.1 The job cannot be printed because it is password-protected. 61:08.2 The job cannot be printed because it contains errors. Resend the job from the Embedded Web Server. 61:09 Resend the job. 63:10 ● Turn off the printer using the Power button at the front. ● Turn off the power switch at the rear. ● Disconnect the power cord. ● Reconnect the power cord and turn on the printer. ● Check that the network cable is correctly connected. ● Ensure that the printer's firmware is up to date. See Update the firmware on page 137. 63:20 A potential problem has been detected in the network interface. ● Turn off the printer using the Power button at the front. ● Turn off the power switch at the rear. ● Disconnect the power cord. ● Reconnect the power cord and turn on the printer. ● Send the same job to the printer again. ● Ensure that the printer's firmware is up to date. See Update the firmware on page 137. 71.03, 71.08 Out of memory. To avoid this, in the HP-GL/2 driver select the Advanced tab and then Send job as a bitmap. 186 Chapter 21 Front-panel error messages ENWW