HP E24q User Guide - Page 13
Mounting the monitor head (select products only), Removing the monitor stand
View all HP E24q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Mounting the monitor head (select products only) The monitor head can be attached to a wall, swing arm, or other mounting fixture. IMPORTANT: This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a thirdparty mounting solution to the monitor head, use four 4 mm, 0.7 pitch, and 10 mm long screws. Longer screws might damage the monitor. Be sure to verify that the manufacturer's mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor head. For best performance, use the power and video cables provided with the monitor. NOTE: This apparatus is intended to be supported by a UL-listed or CSA-listed wall-mount bracket. Removing the monitor stand IMPORTANT: Before disassembling the monitor, be sure that the monitor is turned off and all cables are disconnected. 1. Disconnect and remove all cables from the monitor. 2. Position the monitor facedown on a flat surface covered by protective sheet made of foam or a clean, dry cloth. 3. Push up the latch near the bottom center of the stand's mounting plate (1). 4. Swing the bottom of the stand up until the mounting plate clears the recess in the monitor head (2). 5. Slide the stand out of the recess (3). Setting up the monitor 7