HP ENVY x2 HP Envy x2 Maintenance and Service Guide IMPORTANT! This document i - Page 40
USB/Power Connector board, Remove the base enclosure see
View all HP ENVY x2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
USB/Power Connector board Description USB/Power Connector board Spare part number 702360-001 Before removing the USB/Power connector board, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the base enclosure (see Base enclosure on page 28). 5. Disconnect the battery cable (see Battery on page 29). Remove the USB/Power connector board: 1. Disconnect the USB/Power connector board cable (1). 2. Remove the 3 screws securing the USB/Power connector (2). 3. Remove the USB/Power connector board (3). Reverse this procedure to install the USB/Power connector board and cable. 32 Chapter 4 Removal and replacement procedures