HP OMEN X 35 User Guide - Page 19

Mounting the display head, Removing the monitor stand

Get HP OMEN X 35 PDF manuals and user guides View all HP OMEN X 35 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Mounting the display head The display head can be attached to a wall, swing arm, or other mounting fixture. NOTE: This apparatus is intended to be supported by UL or CSA Listed wall-mount bracket. IMPORTANT: This VESA mount kit supports the VESA industry standard 100 mm mounting holes. To attach a third-party mounting solution to the VESA mount, four 4 mm, 0.7 pitch, and 10 mm long screws are required. Longer screws must not be used because they may damage the monitor. It is important to verify that the manufacturer's mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best performance, it is important to use the power and video cables provided with the monitor. Removing the monitor stand You can remove the display head from the stand to install the display head on a wall, a swing arm, or other mounting fixture. IMPORTANT: Before beginning to disassemble the monitor, be sure the monitor is turned off and all cables are disconnected. 1. Disconnect and remove all cables from the monitor. 2. Loosen the captive screws on the underside of the stand's hinge (1), and then slide the display head off the stand (2). IMPORTANT: Do not lay the monitor face down when removing the stand. Stress on the curvature of the display panel may damage the panel if the monitor is placed face down when removing the stand. Setting up the monitor 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
Mounting the display head
The display head can be attached to a wall, swing arm, or other mounting
fixture.
NOTE:
This apparatus is intended to be supported by UL or CSA Listed wall-mount bracket.
IMPORTANT:
This VESA mount kit supports the VESA industry standard 100 mm mounting holes. To attach
a third-party mounting solution to the VESA mount, four 4 mm, 0.7 pitch, and 10 mm long screws are
required. Longer screws must not be used because they may damage the monitor. It is important to verify
that the manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the
weight of the monitor display panel. For best performance, it is important to use the power and video cables
provided with the monitor.
Removing the monitor stand
You can remove the display head from the stand to install the display head on a wall, a swing arm, or other
mounting
fixture.
IMPORTANT:
Before beginning to disassemble the monitor, be sure the monitor is turned
off
and all cables
are disconnected.
1.
Disconnect and remove all cables from the monitor.
2.
Loosen the captive screws on the underside of the stand’s hinge (1), and then slide the display head
off
the stand (2).
IMPORTANT:
Do not lay the monitor face down when removing the stand. Stress on the curvature of
the display panel may damage the panel if the monitor is placed face down when removing the stand.
Setting up the monitor
13