HP PageWide Managed P75050 Printhead Assembly Install Guide - Page 8
Caution, Important, Reinstall Tip
View all HP PageWide Managed P75050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
8.3 8.4 At the right side of the printer, install the right-rear shipping restraint. CAUTION: Verify that the shipping restraint is locked in place. shipping restraints (supplied in the kit) must be used to avoid the following conditions: • The printhead wiper can slide out of the printhead assembly when it is removed. • The replacement printhead assembly can become misaligned when it is installed. Install the right-front shipping restraint. CAUTION: Verify that the shipping restraint is locked in place. shipping restraints (supplied in the kit) must be used to avoid the following conditions: • The printhead wiper can slide out of the printhead assembly when it is removed. • The replacement printhead assembly can become misaligned when it is installed. 8.5 8.6 1 2 1 2 3 Remove three screws in the following order: Remove one screw (PB1; callout 1), remove one screw (PB2; callout 2), and then remove one screw (PB3; callout 3). IMPORTANT: These screws must be removed/installed in the correct order. REINSTALL TIP: Reinstall these screws in the following order: Install one screw (PB1; callout 1), install one screw (PB2; Callout 2), and then install one screw (PB3; callout 3). At the rear of the printer, disconnect three FFCs (callout 1). CAUTION: One FFC connector (callout 2) is a zero insertion force (ZIF) connector. Open a small clip on the connector to remove the FFC. 8