HP PageWide XL 4700 Assembly Instructions 2 - Page 16
Fix the support to the printer with 4 screws 2 at each
View all HP PageWide XL 4700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
55 56 57 58 EN Remove 4 screws . JA 4 ZHCN 卸下 4 KO 나사 4 Remove the rear bottom right-hand side panel. Remove the E-box support and the clamps from the box. Place the 2 clamps over the support. Fix the support to the printer with 4 screws (2 at each side). 2 4 2 E-Box 2 使用 4 2 E 2 나사 4 2개씩). 16
16
ZHCN
EN
JA
KO
Fix the support to the printer with 4 screws (2 at each
side).
4本のネジ(各側に2本ずつ)でプリンタにサポ
ートを固定します。
使用 4 颗螺钉(每侧 2 颗)将支架固定到打印
机。
나사 4개를 사용하여 지지대를 프린터에 고정합니다
(양쪽에서 2개씩).
Remove 4 screws .
4本のネジを取り外します。
卸下 4 颗螺钉。
나사 4개를 제거합니다.
Remove the rear bottom right-hand side panel.
背面の右下のサイドパネルを取り外します。
取下后下方右侧的面板。
뒷면의 오른쪽 하단 패널을 제거합니다.
Remove the E-box support and the clamps from the
box.
Place the 2 clamps over the support.
ボックスから電子ボックスサポートとクランプ
を取り外します。
2つのクランプをサポートに配置します。
从箱中取出 E-Box 支架和夹具。
在支架 上方放 2 个夹具。
상자에서 E 박스 지지대와 클램프를 꺼냅니다.
클램프 2개를 지지대 위에 놓습니다.
55
57
56
58