HP Pavilion g4 Maintenance and Service Guide - Page 83
Remove the Phillips PM2.5×6.0 screw, Lift the right side of the system board
View all HP Pavilion g4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
3. Release the ZIF connector to which the USB board cable is attached, and then disconnect the USB cable (2) from the system board. 4. Remove the Phillips PM2.5×6.0 screw (1) that secures the system board to the base enclosure. 5. Lift the right side of the system board (2) until it rests at an angle. Component replacement procedures 75
3.
Release the ZIF connector to which the USB board cable is attached, and then disconnect
the USB cable
(2)
from the system board.
4.
Remove the Phillips PM2.5×6.0 screw
(1)
that secures the system board to the base enclosure.
5.
Lift the right side of the system board
(2)
until it rests at an angle.
Component replacement procedures
75