HP Pavilion zt1100 HP Pavilion Notebook PC ZT1000 Series and Omnibook Noteboo - Page 42
Installing Additional RAM
View all HP Pavilion zt1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Add-On Devices Installing Additional RAM Installing Additional RAM Your notebook has no memory (RAM) built in, but has two slots for removable RAM modules: the system RAM slot beneath the keyboard (which contains a module installed at the factory), and an expansion slot on the bottom of the unit. You can use both of these slots to expand your unit's RAM. Use HP PC-133 SDRAM only. You'll need a small Phillips screwdriver for these procedures. CAUTION To install a RAM expansion module To increase your notebook's RAM, you can install a RAM module in the expansion slot on the bottom of the notebook. Your notebook's chips are extremely sensitive to static electricity, and can be permanently damaged by it. Handle the RAM module only by its edges. Before installing the memory module, discharge your body's static electricity by touching the metal shielding around the connectors on the rear of the notebook. 1. Turn off the notebook: click Start, Turn Off Computer, Turn Off. 2. Important: unplug the AC adapter, if present, and remove the battery. 3. From the bottom of the notebook, loosen the screw holding the RAM cover (the cover retains the screw), and remove the cover. 4. Carefully insert the edge of the RAM module into the connector at about a 30° angle until it is fully seated. Then press down on both sides until the latches snap closed. 5. Replace the cover. 6. Insert the battery. To remove the RAM module, release the two latches at the sides of the module. You can also replace the system RAM module beneath the keyboard- see "Installing Additional RAM" in the online Reference Guide. 42 Startup Guide