HP Presario CQ41-100 Compaq Presario CQ41 Notebook PC - Maintenance and Servic - Page 90
into the base enclosure., from the clip built
View all HP Presario CQ41-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Removal and replacement procedures 6. Lift the right side 1 of the system board until it rests at an angle 2. 7. Remove the system board by sliding it to the right at an angle 3 until the connectors on the left side of the system board disengage from the base enclosure. 8. If it is necessary to replace the RJ-11 connector and cable, remove the RJ-11 connector 1 from the clip built into the base enclosure. 9. Remove the cable 2 from the routing channel built into the base enclosure. The RJ-II connector and cable are available using spare part number 494981-001. Reverse this procedure to install the system board. Maintenance and Service Guide 4-51
Removal and replacement procedures
Maintenance and Service Guide
4–51
6. Lift the right side
1
of the system board until it rests at an angle
2
.
7. Remove the system board by sliding it to the right at an angle
3
until the connectors on the left side of the
system board disengage from the base enclosure.
8. If it is necessary to replace the RJ-11 connector and cable, remove the RJ-11 connector
1
from the clip built
into the base enclosure.
9. Remove the cable
2
from the routing channel built into the base enclosure. The RJ-II connector and cable are
available using spare part number 494981-001.
Reverse this procedure to install the system board.