HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.1b release notes (5697-7838 - Page 24

Fabric OS 6.1.1 fixes Table 10 lists defects closed in the Fabric OS 6.1.1 firmware release. Table 10 Fabric OS 6.1.1 closed defects Closed defect summary Solution During storage failover/failback test, traffic stops and fails to recover in single and dual backbone configurations. Fixed in Fabric OS 6.1.1. A failure was detected in the MP Router blade (FR4-18i) due to a dead heartbeat. Fixed in Fabric OS 6.1.1. Link drops when FLOGI is received before the port comes online on an FL_Port. Fixed in Fabric OS 6.1.1. Internal server ports on an embedded platform; traffic may stop due to loss of buffer credit. Fixed in Fabric OS 6.1.1. Mixed fabric of McDATA and Brocade switches cannot be managed if only IPv6 addressing is supported. Fixed in Fabric OS 6.1.1. HBA is not following Fibre Channel protocol standards, which could cause a switch reboot. Fixed in Fabric OS 6.1.1. Problems in an IP network could cause a switch running Fabric OS 5.3.x to panic. Fixed in Fabric OS 6.1.1. Device with slow initialization sequence may cause the switch to mistakenly establish virtual channels on an F_Port. Fixed in Fabric OS 6.1.1. Web tools zoning breaks when third party storage virtualization appliance is changed to standby mode leading to Web Tools hangs. Fixed in Fabric OS 6.1.1. FICON tape write pipelining selectively resets after CmdRetry to NoOp sequence to LBY, causing tape job failures. Fixed in Fabric OS 6.1.1. F_Port link initialization failure exposed by new third-party device behavior, where switch continues to send idles after NOS from HBA. Fixed in Fabric OS 6.1.1. SupportSave command using DCFM does not contain information from the standby CP. Fixed in Fabric OS 6.1.1. HP 400 Multi-Protocol Router sends the wrong sense code during tape backup with pipelining enabled. Fixed in Fabric OS 6.1.1. Web Tools: DCX blade attention LEDs on the switch view GUI window do not turn amber when the blade needs attention. Fixed in Fabric OS6.1.1. FICON PTP VTS selective resets and aborted sequences are caused by incorrect entry into FICON tape read pipelining. Fixed in Fabric OS 6.1.1. After renaming a port group name to blank from Web Tools, the port group is deleted. Fixed in Fabric OS 6.1.1. If EE monitors are restored from flash on a switch that has TopTalker monitors, there is no warning or error when the TopTalker monitor installation recovery fails. Fixed in Fabric OS 6.1.1. 24