HP Vectra VT 6/xxx HP Vectra XU 6/xxx and VT 6/xxx PCs - Technical Reference M - Page 33

MEMORY SIZE Base, on system board Base, on accessory board Base, TOTAL Reserved Extended TOTAL Confirms that Setup has detected and configured the memory size fields Memory hole below 1 MB Tells Setup the size and location of any ISA accessory boards which are memory mapped below 1 MB IDE PRIMARY CHANNEL Device 1 Defines the first primary IDE hard disk drive 512 KB / 640 KB Board's base address (from C800h to DC00h) and memory size (16,32,48 or 64 KB)/ Disabled None or SCSI / Custom Device 2 Data Transfer Speed Translation Method Defines the second primary IDE hard disk drive Sets between EIDE and the original (older) IDE protocol Sets between CHS, ECHS, or LBA Primary Integrated Channel Defines whether or not the integrated IDE controller is used IDE SECONDARY CHANNEL Device 3 Defines the first secondary IDE hard disk drive Device 4 Defines the second secondary IDE hard disk drive Data Transfer Speed Translation Method Sets between EIDE and the original (older) IDE protocol Sets between CHS, ECHS, or LBA Secondary Integrated Channel Defines whether or not the integrated IDE controller is used None or SCSI / Custom Optimized / Standard Automatic / Standard CHS / Extended CHS Enabled / Disabled None or SCSI / Custom None or SCSI / Custom Optimized / Standard Automatic / Standard CHS / Extended CHS Enabled / Disabled Ensure that the TOTAL field is correct. To be used if the installed ISA board has memory mapped below 1 MB (refer to the accessory boards manual). Configuration is automatic for HP IDE hard disk drives. Only use the Custom option for non-HP IDE hard disk drives. Configuration is automatic for HP IDE hard disk drives. Only use the Custom option for non-HP IDE hard disk drives. Select Optimized for maximum performance, or Standard if IDE devices do not work properly. For hard disk drives with more than 1023 cylinders: select Automatic for MS-DOS, Extended CHS for Netware, Standard CHS for Unix. Configure any controller board according to its manual. Configuration is automatic for HP IDE hard disk drives. Only use the Custom option for non-HP IDE hard disk drives. Configuration is automatic for HP IDE hard disk drives. Only use the Custom option for non-HP IDE hard disk drives. Select Optimized for maximum performance, or Standard if IDE devices do not work properly. For hard disk drives with more than 1023 cylinders: select Automatic for MS-DOS, Extended CHS for Netware, Standard CHS for Unix. Configure any controller board according to its manual.