HP Vectra VT 6/xxx HP Vectra XU 6/xxx and VT 6/xxx PCs - Technical Reference M - Page 43
Tests protected RAM in 64 KB segments above 1 MB.
View all HP Vectra VT 6/xxx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
CMOS RAM Test CPU Cache Memory Test Initialize the Video 8042 Self-Test Timer 0/Timer 2 Test DMA Subsystem Test Interrupt Controller Test Real-Time Clock Test Audio Test RAM Address Line Independence Test Size Extended Memory Real-Mode Memory Test (First 640KB) Shadow RAM Test Protected Mode RAM Test (Extended RAM) Checks the CMOS RAM for start-up power loss, verifies the CMOS RAM checksum(s). Test failure causes error codes to display. Tests the processor's cache memories. Test failure causes an error code to be displayed and the boot process to abort. Video Tests Initializes the video subsystem, tests the video shadow RAM, and, if required, shadows the video BIOS. A failure causes an error code to display, but the boot process continues. System Board Tests Downloads the 8042 and invokes the 8042 internal self-test. A failure causes an error code to display. Tests Timer 0 and Timer 2. Test failure causes an error code to display. Checks the DMA controller registers. Test failure causes an error code to display. Tests the Interrupt masks, the master controller interrupt path (by forcing an IRQ0), and the industry-standard slave controller (by forcing an IRQ8). Test failure causes an error code to display. Checks the real-time clock registers and performs a test that ensures that the clock is running. Test failure causes an error code to display. Tests that a SoundBlaster chip is present, and invokes a builtin self-test. Test failure causes an error code to display. Memory Tests Verifies the address independence of real-mode RAM (no address lines stuck together). Test failure causes an error code to display. Sizes and clears the protected mode (extended) memory and writes the value into CMOS bytes 30h and 31h. If the system fails to switch to protected mode, an error code is displayed. Read/write test on real-mode RAM. (This test is not done during a reset using [CTRL] [ALT] and [DELETE]). The test checks each block of system RAM to determine how much is present. Test failure of a 64 KB block of memory causes an error code to display, and the test is aborted. Tests shadow RAM in 64 KB segments (except for segments beginning at A000h, B000h, and F000h). If they are not being used, segments C000h, D000h and E000h are tested. Test failure causes an error code to display. Tests protected RAM in 64 KB segments (above 1 MB). (This test is not done during a reset using [CTRL] [ALT] and [DELETE]). Test failure causes an error code to display.