HP Vectra XA 5/xxx HP Vectra xA 5/XXX Series 5 /vl 5/xxx series 5 pc Technical - Page 27
Serial EEPROM, General Purpose I/O
View all HP Vectra XA 5/xxx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
2 System Board Chip-Set RTC Serial EEPROM General Purpose I/O described on page 37. The real-time clock (RTC) is 146818A-compatible. With an accuracy of 20 ppm (parts per million). The configuration RAM is implemented as 256 bytes of CMOS memory. This is the non-volatile memory which holds the default values for the CMOS memory (in the event of battery failure, or the user pressing in Setup). There are several general purpose I/O pins. Some of these are used on the HP Vectra to sense the current settings of system board switches (page 31 and page 39). Description Reserved (HP security from Little Ben IRQ) Ratio of processor frequency to processor local bus frequency (as per SW-4) Auto soft lock Backplane identification BPID0 (always =0); (see BPID1, below) Host bus frequency selection, as indicated by SW-1 Host bus frequency selection, as indicated by SW-2 Serial EEPROM clear (as per SW-6) Ratio of processor frequency to processor local bus frequency (as per SW-3) Backplane identification BPID1 (desktop=1, minitower=0) Serial EEPROM data out Serial EEPROM data in Serial EEPROM clock Serial EEPROM chip select Reserved (for fax or general purpose light) GPIO number GPIO10 GPIO11 GPIO12 GPIO13 GPIO14 GPIO15 GPIO16 GPIO17 GPIO20 GPIO21 GPIO22 GPIO23 GPIO24 GPIO25 27