HP Visualize J5000 hp Visualize J5000 to J5600 workstation PA8600 upgrade inst - Page 18

Removing the Bus Bar Shield

Get HP Visualize J5000 - Workstation PDF manuals and user guides View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

System Board Removal/Replacement Removing the Bus Bar Shield Removing the Bus Bar Shield 1. Remove the bus bar shield by pulling outward on its latch, and then lifting it up. This shield can be used to hold the screws you will remove in the next step. Figure 2-5 Removing the Bus Bar Shield Step 1: Remove Bus bar Shield Step 2: Remove Bus bar Screws 2. Remove the four T-15 Torx thumbscrews from the power supply bus bar. The bus bar screws are longer than the other T-15 Torx screws. 18 Chapter 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
18
Chapter 2
System Board Removal/Replacement
Removing the Bus Bar Shield
Removing the Bus Bar Shield
1.
Remove the bus bar shield by pulling outward on its latch, and then
lifting it up. This shield can be used to hold the screws you will
remove in the next step.
Figure 2-5
Removing the Bus Bar Shield
2.
Remove the four T-15 Torx thumbscrews from the power supply bus
bar. The bus bar screws are longer than the other T-15 Torx screws.
Step 1: Remove Bus bar Shield
Step 2: Remove Bus bar Screws