HP Visualize J5000 hp Visualize J5000 to J5600 workstation PA8600 upgrade inst - Page 6

Getting Started Safety Warnings WARNING Safety Warnings Removing the device cover may expose sharp edges in the equipment chassis. To avoid injury, use care when installing customer add-on devices. NOTE Before performing removal/replacement procedures, position the workstation on a cushioned flat, stable surface, such as a table top or workbench. NOTE Installing the recommended HP replacement part in your J5000 workstation does not affect the regulatory and safety classifications or approvals listed in the original owner's guide. Electrostatic Discharge (ESD) Precautions To prevent damage to the J5000 workstation, observe all of the following ESD precautions while performing removal and replacement procedures: • Remove all ESD-generating materials from the work area in which you will remove and replace the workstation field replaceable unit(s). • Open the ESD materials provided with the replacement part kit. Unfold the black conductive sheeting (antistatic mat) and place it under a corner of the workstation. • Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your body to ground. Attach the static-grounding wrist strap by following the instructions on the package. Attach the sticky end of the wrist strap to bare metal on the rear panel of the workstation. • Connect all equipment together, including the static-free mat, static strap, clips attached to the wrist strap, nodes, and peripheral units. 6 Chapter 1