HP Visualize J5000 hp Visualize J5000 to J5600 workstation PA8600 upgrade inst - Page 21
Removing and Replacing the System Board
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
System Board Removal/Replacement Removing and Replacing the System Board Figure 2-8 Removing and Replacing the System Board To avoid system damage, make sure your static-grounding strap is securely attached to your wrist and to the bare metal on the workstation. Removing the Old System Board 1. Ensure all workstation cables are out of the way to avoid interference or damage when you remove the system board tray. Removing the System Board T-15 Torx Screws boar tray System Board Handle 2. Remove the two T-15 Torx screws at the back of the workstation that secure the system board tray to the rear wall of the workstation. 3. Grasp the system-board tray handle and slide the system board tray toward the front of the workstation to unseat the keyhole standoffs. Using the handle, lift the system board tray out of the workstation and place it on the conductive sheeting. Chapter 2 21