HP Xw25p ProLiant BL25p Server Blade Maintenance and Service Guide - Page 12
Access panel, Hard drives
View all HP Xw25p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Access panel To remove the component: 1. Power down the server blade and remove it from the server blade enclosure ("Server blade preparation" on page 11). 2. Loosen the thumbscrew. 3. Press down on the thumb indentations, slide the access panel toward the rear of the unit about 1.25 cm (0.5 in), and lift to remove the panel. To replace the component, reverse the removal procedure. Hard drives To install the component: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with either a component or a blank. 1. Remove the hard drive blank. NOTE: Port-colored items indicate hot-plug components. Removal and replacement procedures 12
Removal and replacement procedures
12
Access panel
To remove the component:
1.
Power down the server blade and remove it from the server blade enclosure ("
Server blade
preparation
" on page
11
).
2.
Loosen the thumbscrew.
3.
Press down on the thumb indentations, slide the access panel toward the rear of the unit about 1.25
cm (0.5 in), and lift to remove the panel.
To replace the component, reverse the removal procedure.
Hard drives
To install the component:
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
1.
Remove the hard drive blank.
NOTE:
Port-colored items indicate hot-plug components.