HP Xw25p ProLiant BL25p Server Blade Maintenance and Service Guide - Page 20

Fibre Channel mezzanine (optional

Get HP Xw25p - ProLiant - Blade Workstation PDF manuals and user guides View all HP Xw25p manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

5. Press the fan retention tab and lift the assembly away from the system board. To replace the component, reverse the removal procedure. IMPORTANT: To ensure proper cooling, be sure the correct processor air baffle (on page 18) is installed at all times. Fibre Channel mezzanine (optional) An optional FC mezzanine enables FC support (for clustering capabilities) and SAN connection when used in conjunction with the RJ-45 Patch Panel 2 or the GbE2 Interconnect Switch with FC pass-through option. The card is installed on top of the standard NIC mezzanine card. To remove the component: 1. Power down the server blade and remove it from the server blade enclosure ("Server blade preparation" on page 11). 2. Remove the access panel ("Access panel" on page 12). 3. Loosen the thumbscrews. 4. Lift the FC mezzanine away from the system board. To replace the component, reverse the removal procedure. Removal and replacement procedures 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
Removal and replacement procedures
20
5.
Press the fan retention tab and lift the assembly away from the system board.
To replace the component, reverse the removal procedure.
IMPORTANT:
To ensure proper cooling, be sure the correct processor air baffle (on page
18
) is installed
at all times.
Fibre Channel mezzanine (optional)
An optional FC mezzanine enables FC support (for clustering capabilities) and SAN connection when
used in conjunction with the RJ-45 Patch Panel 2 or the GbE2 Interconnect Switch with FC pass-through
option. The card is installed on top of the standard NIC mezzanine card.
To remove the component:
1.
Power down the server blade and remove it from the server blade enclosure ("
Server blade
preparation
" on page
11
).
2.
Remove the access panel ("
Access panel
" on page
12
).
3.
Loosen the thumbscrews.
4.
Lift the FC mezzanine away from the system board.
To replace the component, reverse the removal procedure.