HP t200 HP Compaq MultiSeat ms6200 Desktop Hardware Reference Guide - Page 21
Installing Additional Memory, DIMMs, DDR3-SDRAM DIMMs
View all HP t200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Table 2-1 System Board Connections (continued) No. System Board Connector System Board Label Color 16 Hood Sensor HSENSE white 17 PCI Express x1 X1PCIEXP1 black 18 PCI Express x1 X4PCIEXP black 19 PCI Express x16 X16PCIEXP black 20 PCI PCI white Component Hood Sensor Expansion Card Expansion Card Expansion Card Expansion Card Installing Additional Memory The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3SDRAM) dual inline memory modules (DIMMs). DIMMs The memory sockets on the system board can be populated with up to four industry-standard DIMMs. These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum memory support, you can populate the system board with up to 16-GB of memory configured in a highperforming dual channel mode. DDR3-SDRAM DIMMs CAUTION: This product DOES NOT support DDR3 Ultra Low Voltage (DDR3U) memory. The processor is not compatible with DDR3U memory and if you plug DDR3U memory into the system board, it can cause the physical damage to the DIMM or invoke system malfunction. For proper system operation, the DDR3-SDRAM DIMMs must be: ● industry-standard 240-pin ● unbuffered non-ECC PC3-8500 DDR3-1066 MHz-compliant or PC3-10600 DDR3-1333 MHz- compliant ● 1.5 volt DDR3-SDRAM DIMMs The DDR3-SDRAM DIMMs must also: ● support CAS latency 7 DDR3 1066 MHz (7-7-7 timing) and CAS latency 9 DDR3 1333 MHz (9-9-9 timing) ● contain the mandatory JEDEC SPD information In addition, the computer supports: ● 512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies ● single-sided and double-sided DIMMs ● DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not supported Installing Additional Memory 15