Hoover CH50100 Product Manual - Page 12
Warning, Important
View all Hoover CH50100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
filter bag: How to replace 4.1 To change filter bag, lift up bag door release latch and pull out. Remove door. 4.2 Grasp plastic bag collar (A) and pull collar from bag support frame (B). Do not pull on paper flap seal. Paper flap will seal the bag opening automatically when removed from the support frame, preventing dust from being released into the air. Discard used filter bag. IMPORTANT Do not clean out old filter bag and reuse. Discard used filter bag. 4.3 Hold new filter bag as shown. Slide plastic bag collar into the bag support frame until the bag is securely in place. Tuck in filter bag. 4.4 Reposition bag door by aligning tabs on bottom of door into openings on cleaner body (C). (Make sure the bag door release latch is lifted up, otherwise, the bag collar will not engage and door will not close.) Close bag door and snap securely shut. Press down on bag door release latch to lock into place. ! WARNING ! To reduce the risk of personal injury, unplug before cleaning or servicing. Do not use vacuum without filter bag in place. 4.1 4.2 B A B 4.3 4.4 Note: Bag door will not latch without bag properly installed. C SECONDARY filter: When to Replace 4.5 When the red indicator light for the filter full illuminates or the unit is not cleaning well, the secondary filter (A) located inside the bag compartment is clogged with dirt or dust; change the secondary filter. 4.5 A Secondary filter: How to Replace ! WARNING ! 4.6 4.7 To reduce the risk of personal injury, unplug before cleaning or servicing. Do not use vacuum without either the secondary or A final filter in place. Secondary Filter The secondary filter is located inside the bag compartment and protects the motor from dirt particles. 4.6 To change the secondary filter first remove the bag door then slide the filter out by grasping and pulling from the bottom (as shown). 4.7 Insert the new filter by lifting the metal safety lever (A) and sliding the new filter in until it is securely in place. Be sure to grab filter by plastic frame and finger loop located on bottom of filter. Reattach bag door. NOTE: Bag door cannot be closed unless filter is in place. 4.8 WHEN FILTER HAS BEEN REPLACED, RESET THE "FILTER FULL" INDICATOR ON THE LED DIAGNOSTIC PANEL (SEE PAGE 14). What to Buy Use only genuine Hoover Secondary Filters with your vacuum. When purchasing a new Secondary Filter, ask for ® Hoover Part No. 440001913 12