Hoover CH50100 Product Manual - Page 13
Final Filter
View all Hoover CH50100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
FINAL filter: When to Replace 4.9 4.9 The final filter (A) located on top of the nozzle should be changed when A clogged with dirt or dust. Inspect regularly or when changing the second- ary filter. FINAL filter: How to Replace ! WARNING ! To reduce the risk of personal injury, unplug before cleaning or servicing. Do not use vacuum without either the secondary or final filter in place. 4.10 To remove this filter when it becomes dirty, first release the handle all the way to the floor by stepping on the handle release lever (B) twice. 4.11 To remove final filter, pull tab (C) forward. Remove filter cover and filter. Insert a new filter and replace the filter cover. What to Buy Use only genuine Hoover Final Filters with your vacuum. When purchasing a new Final Filter, ask for ® Hoover Part No.440001914. 4.10 C 4.11 B BRUSHROLL: When to Clean or Replace When the red indicator light above the brushroll check icon illuminates and is blinking, the brushroll is jammed and needs checked and cleaned. When the red indicator light above the brushroll check icon illuminates and stays on, the brushroll bristles are worn and the brushroll needs replaced. It is also advised to check occasionally for excess hair or fiber wrapped around the brushroll. BRUSHROLL: How to Clean or Replace ! WARNING ! To reduce the risk of personal injury from moving parts, unplug vacuum before servicing. 4.12 A 4.12 B 4.12 To remove the brushroll, tilt nozzle on its side with brushroll side plate up. Push the brushroll release button (A) forward and remove the side plate (B). 4.13 Twist brushroll forward and lift brushroll out. If cleaning, remove any debris and/or hair from the brushroll. If replacing, discard old brushroll and install a new one. 4.14 To reinstall the brushroll, slide the brushroll back into the brush housing and twist it backwards until it locks in place. 4.15 Press the side plate (C) back onto the nozzle, until it locks into place. 4.16 If you've replaced the brushroll with a new one, reset the brushroll check indicator on the LED Diagnostic Panel (see page 14). 4.13 4.14 4.13 4.15 C What to Buy Use only genuine Hoover Brushroll with your vacuum. When purchasing a new Brushroll, ask for Hoover Part No. 440001916. 13